Gfb Short Shift Basic Kit for STi 6 speed transmission Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro auto Gfb Short Shift Basic Kit for STi 6 speed transmission. GFB Short Shift Basic Kit for STi 6 speed transmission (part 4003) User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Instructions for GFB Short Shift Basic Kit for STi 6 speed transmission
Included in kit:
1 x gearstick
1 x pin remover, including:
2 x M5 slot screws
1 x 4mm hex key
1 x cable/zip tie
Required tools:
2 x 12mm spanner/wrench
Medium flat-blade and Phillips screwdriver
Side cutters/knife
Circlip pliers (or pointy needle-nose pliers
will suffice)
Rag
GFB Short Shift Kits carry a lifetime warranty which covers faulty components or manufacturing. Warranty is limited only to the
repair or replacement of GFB products provided they are used as intended and in accordance with all appropriate warnings and
limitations. No other warranty is expressed or implied.
We HIGHLY recommend you read through the instructions and familiarise yourself with the steps
before starting installation of this product.
1. Lift the lid of the centre console between the seats
above the handbrake. On the plastic handbrake shroud
there are two slots, using the flat-blade screwdriver
padded with a rag, carefully lever the shroud up on
each side (there is a pop-type fastener on each side).
2. Lift the handbrake shroud out (taking care of wiring
still attached), to give you access to the gearstick
surround (figure 2).
3. Unscrew the gear knob and unclip the button fastener
on the leather shift boot. Gently lift the plastic
gearstick shroud up from the back, it is only lightly clipped in and does not need much force.
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1

Instructions for GFB Short Shift Basic Kit for STi 6 speed transmission Included in kit: • 1 x gearstick • 1 x pin remover, including: 2 x M

Strany 2

4. Slide the pin remover onto the top of the gearstick (fig. 4). Thread the longer of the M5 slot screws into the threaded hole of the p

Strany 3

10. At this point it is necessary to lock the reverse cable in an extended position in order to be able to replace the roll pin. To do th

Strany 4

14. IMPORTANT: Make sure the factory steel sleeve is inserted into the white bushings of the gearstick clamp – without this sleeve the shifter will

Komentáře k této Příručce

Žádné komentáře